Monument 2069 Compression Fitting Spanner, 24 x 32 mm

Product Information

Copper pipe works well with compression fittings. Chrome plated copper pipe also works well. Some advocate stripping the chrome from the area of the pipe in the fitting as this allows the olive to get a better grip on the pipe. There is no actual need to do this, but if not doing so, it is advisable to torque the nuts a little higher than with normal copper pipe since its harder for the olive to "bite" the chromed pipe. Also means that you have twice the number of positions that the spanner can engage with the nut. This is very handy when there is very limited turning space for the spanner. One of the difficulties with compression fittings is that while the nuts are usually a nominal size, there is not agreed standard tolerance between manufacturers. This can make selecting a single universal spanner difficult. Also not all spanner types can be used in all situations. Hence most plumbing kits will have a number of spanners, including at least one adjustable one. The most effective "cure all" sealants are the silicone based "setting" sealants like Fernox LS-X. These will usually seal most problem joints so long as the olive is actually meeting the fitting body when the nut is tightened.

Again, a clean square cut is important, and any burrs removed. Take great care to protect pipe ends when pulling them under floors etc, since its very easy to scratch plastic pipe and this makes it hard to get a good compression (or pushfit for that matter) seal. The other way is to use a few turns of PTFE tape to the threads. Note that used this way the PTFE will not aid the sealing of the joint, but it will make the nuts easier to torque up.

New Customers

Plastic pipe can be joined with compression fittings, however it is important to use the correct brand of pipe insert to support the end of the pipe, or else the joint may start to leak over time. Once the nuts are done up hand tight on the joint, an additional half to three quarter turn with a pair of spanners (one on the body of the fitting to hold it still, the other on the nut) is usually adequate to make a seal. If the joint leaks, an additional tightening tweak will normally fix it. Note that over-tightening a joint may actually make it leak. The pipe needs to be cut square and cleanly, with any burrs removed. Pipes cut with a pipe cutter are much easier to use than those cut with a saw. The pipe needs to be clean and free from contaminants like paint or plaster etc. It does not need to be quite as clean and shiny as required for soldered connections.

These are far better suited, are long enough to get good leverage and are comfortable to use. The design of the end wraps around more of the nut giving better support and greatly reducing the risk of damaging a nut: The partially "open" end allows the spanner to slip over a pipe, and then slid onto the nut.

Frequently Purchased Together

Most tool kits will include a set of these. While not the perfect tool, they can be very useful since they will adapt to make a good fit on any nut. If you use them with the correct orientation they also grip harder the more force you apply to them: